Hydromatic Sewage Pump, SK

Hydromatic Sewage Pump, SK

Features

  Carbon/Ceramic Type 21 Shaft Seal

  Oil-Filled Motor with Automatic Reset Thermal Overload for Maximum Protection (single phase models)

  Upper and Lower Single Row Ball Bearing Construction

  Piggyback Plug Available for Easy Maintenance and Switch Replacement

  Submersible, Two-Vane, Semi-Open Cast Iron Impeller

Specifications

  BODY CONSTRUCTION: Class 30 Cast Iron

  HORSEPOWER: Available in 1/2, 1, 1-1/2, and 2 HP

  MAXIMUM HEAD: SKHS200: 75 ft. (22.9 m)

  MAXIMUM CAPACITY: SKHS200: 175 GPM (11.0 LPS)

  FLOW at 10' LIFT: 10' of Head is Below Recommended Head for This Series

  SWITCH TYPE: Wide-angle Tethered Float Switch OR Manual Operation (model dependent)

  MINIMUM SUMP DIAMETER: Simplex: 18" / Duplex: 30"

  DISCHARGE PIPE SIZE: 2" NPT (3" NPT optional)

  MAXIMUM SOLIDS HANDLING SIZE: 2"

  AMP DRAW (full load): Model and Voltage Dependent - See Spec Sheet For Details

  CORD LENGTH: 10' SJTW (20' optional)

  VOLTAGE: 115v or 230v in 1- or 3-phase (model dependent)

  MAXIMUM LIQUID TEMPERATURE: 130 Degrees F (54 Degrees C)

  MOTOR: Split Phase with Thermal Overload Protection

  IMPELLER CONSTRUCTION: Class 30 Cast Iron